RCF安装失败、并显示错误"Invalid range at '^' marker"。在分支端口上

最后更新
另存为PDF

Views:: 1

Visibility:: Public

Votes:: 0

Category:: fabric-interconnect-and-management-switches<a>2009628340</a>

Specialty:: hw

Last Updated:

适用场景

Cisco Nexus 9334C -适用于
参考配置文件(RCF)

问题描述

安装RCF文件时 NX9336C-FX2-RCF-v1.10-Shared.txt 、 e1/10/1-4 无法识别端口范围。
下面的每个命令都将失败并显示错误 % Invalid command at '^' marker。

`PR2-CS-SW2(config)# interface e1/1-8, e1/9/1-4, e1/10/1-4`
                            ^
 Invalid range at '^' marker.
 `PR2-CS-SW2(config)# inherit port-profile CLUSTER_HA`
                       ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2(config)# priority-flow-control mode auto`
                                           ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2(config)# service-policy type qos input HA_POLICY`
                            ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2(config)# exit`
 `PR2-CS-SW2# interface Ethernet 1/11-22`
                  ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# inherit port-profile STORAGE`
               ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# priority-flow-control mode on`
                                   ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# priority-flow-control watch-dog-interval on`
                                   ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# service-policy type qos input STORAGE_POLICY`
               ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# switchport vlan mapping 30 dot1q-tunnel 31`
                   ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# switchport trunk native vlan 33`
                   ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# switchport trunk allowed vlan 31,33`
                   ^
 % Invalid command at '^' marker.
 `PR2-CS-SW2# exit`
 Copy complete, now saving to disk (please wait)...